Discussion in 'DIY & MYOG' started by stormin', Jun 22, 2019.
If this is something for yourself then I certainly admire your ingenuity if this is a commercial venture (you mentioned selling it in your video) I don’t think I would want pop-rivets scrapping up and down the side of the pot and thingamabobs to stop handles from heating up.
I think you’ll need to watch the handle retainer on the pot too, as you put it back in the pot cosy it had the potential to catch it.
Just a bit of honest feedback
Thanks for your feedback @fossilbluff.The rivets are domed heads and the reverse is smooth, The piece of carbon felt is a standy in case the handle got overly heated, which it did not.The pot cosy is one of the first I made for my own use, the cosys I supply with the Solo System and the Cold soak optional System are of a larger diameter, to avoid the handle fixing snagging the cosy.
How did you find the heat deflection toward the top of the canister... your vid didn’t show that because you were rightly focusing on your design.
How was / is it?
How was / is it?[/QUOTE]
As can be observed in the video, I comment on this whilst my fingers/ hands are in contact with the canister and on/ off valve.
As can be observed in the video, I comment on this whilst my fingers/ hands are in contact with the canister and on/ off valve.[/QUOTE]
Yeah, I saw that... but it was about 15 seconds after you lit it. Which is why I was asking I suppose...
Anyway you know what your doing, I was just curious
I don't think you'll have to worry about TD copying it
Looks. Far too much faff. The DoE brigade may like it.
Has it been tested in a typical mountain/Moor environment? Wind, rain, snow etc?
If your selling it as a kit... Your missing the canister stand... Ali do them very cheap.
Separate names with a comma.