If you would like to know what mine needed:
- The cord on the pitchlock corners isnt quite long enough if you want to share the pegs with the fly sheet so you could replace it - or what I've done is added a loop of 3mm shock cord to each cord to give it a bit extra length and flex. I'll probably just stick with this.
- The adjustable hanging point is a brass eyelet, Hexpeak V4 i think have an O ring at the top so this will need to be fixed so they can connect, I've attached a small Krab to the brass eyelet of the inner for now (the O ring at the Hexpeak apex is quite hard to get to i found, its quite short when a pole is in the way)
Two minor points
- The corner cords need a knot in the cord a couple of inches from the end so you have something to grab and pull without it getting stuck in the lineloc.
- the door tie back toggles are a bit loose, so I've added a small shockcord loop to each one so i can tie them back.
Other than that you should be good to go.